Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test J : P0230:12, P0230:14: Notes
P0230:12, P0230:14
Refer to Electronic Engine Controls - 6.8L for schematic and connector information.
Refer to Electronic Engine Controls - 6.2L for schematic and connector information.
Normal Operation and Fault Conditions
The BCM provides ground to the coil side of the BJB fuel pump relay.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0230:12 | Fuel Pump Primary Circuit: Circuit Short To Battery | A continuous and on-demand DTC that sets when the BCM detects a short to voltage from the fuel pump relay coil circuit. |
| P0230:14 | Fuel Pump Primary Circuit: Circuit Short To Ground or Open | A continuous DTC that sets when the BCM detects a short to ground or open from the fuel pump relay coil circuit. |
Possible Sources
- Fuse
- Wiring, terminals or connectors
- Fuel pump relay
- BCM
Visual Inspection and Diagnostic Pre-Checks
Inspect BJB fuse 75 (30A).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.