SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 148 (OEM CONNECTOR END VIEWS - C100 - C332)CONNECTOR VIEWSCONNECTOR END VIEW (C221) - INLINE
2021 Ford Edge SE, 4WD

Connector End View (C221) - INLINE

2021 Ford Edge SE, 4WDSECTION Connector End View (C221) - INLINE
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Inline: Description Color Harness Base Part # Service Pigtail
C221 INLINE LT GY 12A58119F561 See Below

MALE 

Harness 

12A581

FEMALE 

Harness 

19F561

GFDWR56277Courtesy of FORD MOTOR COMPANY
GFDWR56278Courtesy of FORD MOTOR COMPANY
Terminal Part Number  Service Part Number  Size 
XW4T-14421-EA KU2Z-14421-AA 6.3
XW4T-14474-TA JU2Z-14474-AB 6.3
Pin  Circuit  Gauge  Qualifier  Terminal Part Number 
1 * * N/A
2 CBB84 (VT) 10 XW4T-14421-EA
3 CBB83 (GY) 10 XW4T-14421-EA
Pin  Circuit  Gauge  Qualifier  Terminal Part Number 
1 * * N/A
2 CBB84 (VT) 10 XW4T-14474-TA
3 CBB83 (GY) 10 XW4T-14474-TA

Available Pigtail Kits 

Pigtail Kit Part Number WPT-1408

GFDWR40801Courtesy of FORD MOTOR COMPANY

Service Part Number:

EU2Z-14S411-XA 

Gauge:

10 

Pin material:

Tin 

Cavities:

4 

Vehicle Uses:

  • Mating Connector WPT-1177
  • Switch - Upfitter

Pigtail Kit Part Number WPT-1177

GFDWR12957Courtesy of FORD MOTOR COMPANY

Service Part Number:

AU2Z-14S411-BHA 

Gauge:

10 

Pin material:

Tin 

Cavities:

4 

Vehicle Uses:

  • Mating Connector WPT-1408
  • Resistor - Blower Motor (Front)
  • Switch - Heater / A/C Blower (Front)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.