Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation and Fault Conditions
2021 Ford Edge SE, 4WDSECTION Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2018 Lincoln MKX and 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the SECM monitors various inputs to detect if a fault is present.
SECM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U3000:19 | Control Module: Circuit Current Above Threshold | Sets when the SECM detects the electrical current to the locking solenoid is above a specified level. This DTC setting multiple times is a trigger condition for DTC U3000:96. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.