Normal Operation and Fault Conditions

2021 Ford Edge SE, 4WDSECTION Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2018 Lincoln MKX and 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the SECM monitors various inputs to determine if the motor is operating correctly.Β 

SECM DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
C100B:62 Motor Drive Current: Signal Compare Failure Sets when the SECM detects the electrical current required to drive the adaptive steering motor does not match what is expected. This DTC setting multiple times is a trigger condition for DTC U3000:96.
C100C:63 Steering Tracking: Circuit/Component Protection Time-Out Sets when the SECM detects the steering angle offset (clear vision) is too great for the SECM to compensate.
U3000:68 Control Module: Event Information Sets when the SECM detects an internal fault.
U3000:98 Control Module: Component or System Over Temperature Sets when the SECM detects an internal fault.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.