Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Conditioning Module (F-650/F-750)
| Item | Number | Description |
|---|---|---|
| 1 | - | Fuel Return Line To The Fuel Tank |
| 2 | - | Electric Fuel Pump Electrical Connector |
| 3 | - | Fuel Supply Line From The Fuel Tank |
| 4 | - | Fuel Supply Line To The Secondary Fuel Filter |
| 5 | - | Fuel Return Line From The Secondary Fuel Filter |
| 6 | - | Fuel Filter Cover |
| 7 | - | Fuel Drain Valve |
| 8 | - | WIF Sensor Electrical Connector |
Fuel Conditioning Module - Transit
The internal components of the fuel conditioning module include the following:
- 10 micron fuel filter and water separator
- water in fuel (WIF) sensor
- recirculation thermostat
The fuel pump (FP) assembly supplies fuel from the fuel tank through the fuel supply line. When the fuel enters the fuel conditioning module, water is separated from the fuel before it flows through the 10 micron fuel filter which separates particles from the fuel. The separated water collects at the bottom of the pump. If enough water is collected, the WIF sensor detects it and the PCM illuminates the WIF indicator. The conditioned fuel is then delivered to the high pressure fuel injection pump.
The vented fuel from the fuel pressure control valve returns from the high pressure fuel injection pump, combines with the fuel from the fuel injector return line and enters the unfiltered side of the fuel conditioning module. Depending on the fuel temperature returning from the high pressure fuel injection pump, the recirculation thermostat directs the fuel through the fuel cooler back to the fuel tank or through the fuel conditioning module back to the high pressure fuel injection pump.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.