Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 136 (TIRE PRESSURE MONITORING SYSTEM (TPMS))
2021 Ford Edge SE, 4WD
Section 136 (Tire Pressure Monitoring System (TPMS))
2021 Ford Edge SE, 4WDSECTION Section 136 (Tire Pressure Monitoring System (TPMS))
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Tire Pressure Monitoring System (TPMS)
- DTC Chart(s)
- Symptom Chart: Tire Pressure Monitoring System
- Pinpoint Tests
- Pinpoint Test A : B1182:00 - BCM (Body Control Module)
- Pinpoint Test B : Diagnosing Radio Frequency Interference Faults
- Pinpoint Test C : The Vehicle TPMS (Tire Pressure Monitoring System) Warning Indicator Is On Continuously And The Message Center Displays Low Tire Pressure
- Pinpoint Test D : The BCM (Body Control Module) Does Not Enter TPMS (Tire Pressure Monitoring System) Sensor Training Mode
- Pinpoint Test E : One Or More Vehicle Or Trailer TPMS (Tire Pressure Monitoring System) Sensors Do Not Train And No Diagnostic Trouble Codes (DTCS) Are Present
- Pinpoint Test F : U0146:00 - RTM (Radio Transceiver Module)
- Pinpoint Test G : U1A00:00
- Pinpoint Test H : U0401:00, U0401:82
- Pinpoint Test I : B1182:00 - GFM (Generic Function Module)
- Pinpoint Test J : U0146:00 - GFM (Generic Function Module)
- Pinpoint Test K : U3003:16
- Pinpoint Test L : The Message Center Displays Low Trailer Tire Pressure
- Tire Pressure Monitoring System (TPMS)
- General Procedures
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.