Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Tests WA: Exhaust Gas RECIRCULATION Temperature (EGRT) Sensor: Introduction
2021 Ford Edge SE, 4WDSECTION Introduction
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
- harness circuits: EGRT11, EGRT12, and SIGRTN
- EGRT11 and EGRT12 sensors
- PCM (12A650)
| Vehicle | Connector | Pin | Circuit |
|---|---|---|---|
| F-650/F-750, F-Series Super Duty |
A | 2 1 |
SIGRTN EGRT11 |
| F-150, Transit |
A | 1 2 |
SIGRTN EGRT11 |
| Pin | Circuit |
|---|---|
| 2 | SIGRTN (Signal Return) |
| 1 | EGRT12 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 2) |
| Pin | Circuit |
|---|---|
| 37 | EGRT12 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 2) |
| 4 | SIGRTN (Signal Return) |
| 27 | EGRT11 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 1) |
| Pin | Circuit |
|---|---|
| 45 | SIGRTN (Signal Return) |
| 32 | EGRT12 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 2) |
| 53 | SIGRTN (Signal Return) |
| 7 | EGRT11 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 1) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.