Pinpoint Tests V: Camshaft Position (CMP) Sensor: Introduction

2021 Ford Edge SE, 4WDSECTION Introduction
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

  • harness circuits: VREF, CMP11 and SIGRTN
  • CMP11 sensor (12K073)
  • PCM (12A650)
Fig 1: Camshaft Position Bank 1 Sensor 1 (CMP11) Sensor Connector
G12084345Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
F-150 A 2
1
3
SIGRTN
CMP11
VREF
Transit A 2
3
1
SIGRTN
CMP11
VREF
All other vehicles B 3
2
1
SIGRTN
CMP11
VREF
Fig 2: Powertrain Control Module-E (PCM-E) Connector
G12084346Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
F-650/F-750 A 47
32
SIGRTN
CMP11
Transit B 34
4
SIGRTN
CMP11
All other vehicles A 25
32
SIGRTN
CMP11
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.