Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Tests RK: REDUCTANT Injector: Introduction
2021 Ford Edge SE, 4WDSECTION Introduction
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
- reductant injector
- harness circuits: RDINJPWR and RDINJGND
- reductant dosage control module (5H298)
- PCM (12A650)
| Vehicle | Connector | Pin | Circuit |
|---|---|---|---|
| F-650/F-750 | A | 2 1 |
RDINJGND RDINJPWR |
| Transit | B | 2 1 |
RDINJGND RDINJPWR |
| All other vehicles | A | 1 2 |
RDINJGND RDINJPWR |
| Pin | Circuit |
|---|---|
| 91 | RDINJGND (Reductant Injector Ground) |
| 74 | RDINJPWR (Reductant Injector Power) |
| Pin | Circuit |
|---|---|
| 14 | RDINJGND (Reductant Injector Ground) |
| 21 | RDINJPWR (Reductant Injector Power) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.