Pinpoint Tests K: Engine Coolant Temperature (ECT) Sensor: Introduction

2021 Ford Edge SE, 4WDSECTION Introduction
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

  • ECT sensor (12A648)
  • secondary cooling system engine coolant temperature 2 (ECT2) sensor (12A648)
  • harness circuits: ECT, ECT2 and SIGRTN
  • PCM (12A650)
TEMPERATURE VS. RESISTANCE VALUES (APPROXIMATE)

Β°C Β°F Ohms
100 212 2, 080
90 194 2, 803
80 176 3, 836
70 158 5, 337
60 140 7, 556
50 122 10, 908
45 113 13, 216
40 104 16, 092
35 95 19, 696
30 86 24, 329
25 77 30, 000
20 68 37, 352
15 59 46, 797
10 50 59, 016
5 41 74, 940
0 32 95, 851
-5 23 123, 485
-10 14 160, 313
-15 5 209, 816
-20 -4 276, 959
-30 -22 496, 051
-40 -40 925, 021
Fig 1: Engine Coolant Temperature (ECT) Sensor Connector
G12084261Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
F-150 A 2
1
SIGRTN
ECT
All other vehicles B 2
1
SIGRTN
ECT
Fig 2: Engine Coolant Temperature 2 (ECT2) Sensor Connector
G07432357Courtesy of FORD MOTOR CO.
Pin Circuit
2 SIGRTN (Signal Return)
1 ECT2 (Engine Coolant Temperature 2)
Fig 3: Powertrain Control Module-E (PCM-E) Connector
G12084263Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
F-150 A 4
28
4
SIGRTN
ECT
SIGRTN
Transit B 18
22
ECT
SIGRTN
All other vehicles A 4
28
4
31
SIGRTN
ECT
SIGRTN
ECT2
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.