Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P2A01 - O2 SENSOR CIRCUIT RANGE/PERFORMANCE (BANK 1 SENSOR 2)
2021 Ford Edge SE, 4WD
DTC P2A01 - O2 Sensor Circuit Range/Performance (Bank 1 Sensor 2)
2021 Ford Edge SE, 4WDSECTION DTC P2A01 - O2 Sensor Circuit Range/Performance (Bank 1 Sensor 2)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P2A01 - O2 SENSOR CIRCUIT RANGE/PERFORMANCE (BANK 1 SENSOR 2)
| Description: | The nitrogen oxides bank 1, sensor 2 (NOx12) module estimates the expected exhaust oxygen (O2) content during certain fuel, boost and exhaust gas recirculation (EGR) conditions. This DTC sets when the actual NOx12 sensor O2 signal value is not within the expected range for a calibrated amount of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument cluster message center. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST RD . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.