Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P2085 - EXHAUST GAS TEMPERATURE SENSOR CIRCUIT INTERMITTENT (BANK 1 SENSOR 2)
2021 Ford Edge SE, 4WD
DTC P2085 - Exhaust Gas Temperature Sensor Circuit Intermittent (Bank 1 Sensor 2)
2021 Ford Edge SE, 4WDSECTION DTC P2085 - Exhaust Gas Temperature Sensor Circuit Intermittent (Bank 1 Sensor 2)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P2085 - EXHAUST GAS TEMPERATURE SENSOR CIRCUIT INTERMITTENT (BANK 1 SENSOR 2)
| For Transit | |||
| Description: | This DTC sets when the DTC P2033 is set. The exhaust fluid system fault message may be enabled in the instrument cluster message center for this DTC. | ||
| Possible Causes: | |||
| Diagnostic Aids: | This DTC is an informational DTC and may be accompanied by other DTCs. Diagnose all other DTCs first. The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle, while carrying out the appropriate drive cycle procedure, until the system warning message has cleared from the instrument cluster message center. Refer to DRIVE CYCLES , for additional information. For F-Series Super Duty, this DTC is present for 400 days after the exhaust system fluid fault message is cleared. |
||
| For All Others | |||
| Description: | This DTC sets when an intermittent concern is detected in the EGT12 circuit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Harness routing, harness alterations, or incorrect shielding may have an intermittent impact on the EGT12 circuit. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Transit | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
| All others | GO to PINPOINT TEST RC . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.