Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P1703 - BRAKE SWITCH OUT OF SELF TEST RANGE
2021 Ford Edge SE, 4WD
DTC P1703 - Brake Switch Out Of Self Test Range
2021 Ford Edge SE, 4WDSECTION DTC P1703 - Brake Switch Out Of Self Test Range
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P1703 - BRAKE SWITCH OUT OF SELF TEST RANGE
| Description: | The DTC sets when the key ON, engine OFF (KOEO) self-test is carried out, and the brake pedal position (BPP) switch signal is high, or during the key ON, engine running (KOER) self-test, the BPP switch signal does not cycle high and low. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Using the diagnostic tool, check the BOO1 PID. The stoplamps and BOO1 PID should turn ON and OFF with brake pedal activation. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST AI . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.