SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0219 - ENGINE OVER SPEED CONDITION
2021 Ford Edge SE, 4WD

DTC P0219 - Engine Over Speed Condition

2021 Ford Edge SE, 4WDSECTION DTC P0219 - Engine Over Speed Condition
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P0219 - ENGINE OVER SPEED CONDITION

Description:  This DTC sets when the vehicle has been operated in a manner which caused the engine speed to exceed a calibrated limit. The engine RPM is continuously monitored and evaluated by the PCM.
For additional information on the engine RPM limiter, refer to CATALYST EFFICIENCY MONITOR .
Possible Causes: 
  • Wheel slippage (water, ice, mud, and snow)
  • Excessive engine RPM in NEUTRAL or operated in the incorrect transmission gear
  • High engine RPM with engine temperature within a calibrated limit of an overheating condition (GTDI engine)
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If DTC P1285 or P1299 is present, disregard DTC P0219 at this time. Diagnose DTC P1285 or P1299 first.
If there are no other symptoms, return the vehicle to the customer with information about the DTC.
If a symptom is present, refer to NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHART INDEX .
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.