Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (DIESEL))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P0093 - FUEL SYSTEM LEAK DETECTED - LARGE LEAK
2021 Ford Edge SE, 4WD
DTC P0093 - Fuel System Leak Detected - Large Leak
2021 Ford Edge SE, 4WDSECTION DTC P0093 - Fuel System Leak Detected - Large Leak
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
P0093 - FUEL SYSTEM LEAK DETECTED - LARGE LEAK
| Description: | This DTC sets when the requested fuel volume control value exceeds a calibrated threshold indicating a large fuel system leak. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The fuel pressure in the high pressure fuel system can be monitored by accessing the FRP_A PID on the scan tool. The PCM may disable the low pressure fuel pump causing a no start condition when this DTC sets. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST M . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.