Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Tests QB: Keep Alive Power (KAPWR): Introduction
2021 Ford Edge SE, 4WDSECTION Introduction
This pinpoint test is intended to diagnose the following:
- battery terminal condition
- KAPWR wire routing
- harness circuit: KAPWR
- powertrain control module (PCM) (12A650)
Powertrain Control Module (PCM) Connector
For PCM connector views or Reference values, Refer to Reference Values.
| Vehicle | Connector | Pin | Circuit |
|---|---|---|---|
| Ford GT | 198 PIN | B100 | KAPWR |
| Ranger | 128 PIN | B10 | KAPWR |
| Transit | 306 PIN | B100 | KAPWR |
| All other vehicles | 112 PIN | B10 | KAPWR |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.