Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (BATTERY, MOUNTING AND CABLES)REMOVAL AND INSTALLATIONBATTERY TRAYREMOVAL
2021 Ford Edge SE, 4WD
Battery Tray: Removal
2021 Ford Edge SE, 4WDSECTION Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the air cleaner. Refer to: Air Cleaner - 2.0L EcoBoost . Refer to: Air Cleaner - 2.7L EcoBoost
- Remove the battery. Refer to: Battery
-
NOTE: Typical battery cable and tray shown, other battery cables and trays similar.
Disconnect the battery cable and engine wire harness retainers from the battery tray.
-
- Remove the M6 x 18mm bolts.
Torque
: 55 lb.in (6.2 Nm)
- Remove the M6 x 30mm bolts and the battery tray.
Torque
: 55 lb.in (6.2 Nm)
- Remove the M6 x 18mm bolts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.