Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U034B: Software Incompatibility With Brake Booster Control: Description
Some engines are also equipped with a VSV. The VSV replaces the traditional vacuum check valve usually located in the brake booster. The VSV is located in the vacuum harness and is used for stop-start applications, to shut off air conditioning in warm or hot markets and to supply additional vacuum to the brake booster for brake performance during specific driving conditions.
The VSV is controlled by the PCM. When the demand for vacuum increases, the PCM grounds the VSV and vacuum is routed to the brake booster. The PCM must be configured correctly for VSV operation, if a VSV is installed on a vehicle and the PCM is not configured for a VSV, this DTC sets.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.