SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSU0422 - INVALID DATA RECEIVED FROM BODY CONTROL MODULE
2021 Ford Edge SE, 4WD

U0422 - Invalid Data Received From Body Control Module

2021 Ford Edge SE, 4WDSECTION U0422 - Invalid Data Received From Body Control Module
DTC DESCRIPTION U0422 - INVALID DATA RECEIVED FROM BODY CONTROL MODULE

Description:  Network DTC concerns occur during module to module communication.
Possible Causes: 
  • Invalid data network concerns - data is transferred within the normal inter-module message, but contains known invalid data. The transmitting module logs a DTC related to the invalid data concern.
  • Missing message network concerns - missing message concerns are logged by the module upon failure to receive a message from another module within a defined retry period.
Diagnostic Aids:  Check for all other module DTCs or related symptoms. Diagnose all other module DTCs before diagnosing this DTC. Reprogram the BCM, instrument cluster, and PCM using as built data. Refer to Flash Electrically Erasable Programmable Read Only Memory (EEPROM), Programming The VID Block For A Replacement PCM, to reprogram the PCM.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test QA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.