P0610 - Control Module Vehicle Options Error

2021 Ford Edge SE, 4WDSECTION P0610 - Control Module Vehicle Options Error
DTC DESCRIPTION P0610 - CONTROL MODULE VEHICLE OPTIONS ERROR

Description:  This DTC sets when one or more of the PCM VID Block fields were configured incorrectly.
Possible Causes: 
  • Module reprogramming
  • Aftermarket performance products
  • Damaged PCM
Diagnostic Aids:  Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Check for aftermarket performance products. If it is necessary to install a new PCM, refer to Flash Electrically Erasable Programmable Read Only Memory (EEPROM), Programming the VID Block for a replacement PCM.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test QA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.