Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSREAR SEATSREMOVAL AND INSTALLATIONREAR SEAT ARMRESTREMOVAL
2021 Ford Edge SE, 4WD
Rear Seat Armrest: Removal
2021 Ford Edge SE, 4WDSECTION Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the inboard child safety seat tether anchor bezel.
- Release the backrest lower J-clip. Unzip the inboard backrest cover and remove the armrest fasteners.
Torque
: 80 lb.in (9.0 Nm)
- Lower the armrest and release the armrest back panel upper locking clips from the backrest frame.
- Detach the backrest cover from the armrest hooks. Detach the J-clip and remove the armrest.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.