Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021BRONCO BADLANDS, 2D UTILITY, 2.7L ENG VIN P, PART TIME T/CASE CONTROLREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDTC INDEX (POWER STEERING SYSTEM - WIPER SYSTEM AND WASHER SYSTEM)WIPER SYSTEM AND WASHER SYSTEM DTCS
2021 Ford Bronco Badlands, 2D Utility, 2.7L Eng VIN P, Part Time T/Case Control
Wiper System And Washer System DTCS
2021 Ford Bronco Badlands, 2D Utility, 2.7L Eng VIN P, Part Time T/Case ControlSECTION Wiper System And Washer System DTCS
| DTC | Description | Action |
|---|---|---|
| B130F:12 | Run Accessory Control: Circuit Short To Battery | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test D |
| B1131:01 | Wiper motor module: General Electrical Failure | GO to Pinpoint Test A |
| B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test A |
| B1131:02 | Wiper Motor Module: General Signal Failure | GO to Pinpoint Test D |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:49 | Wiper Motor Module: Internal Electronic Failure | GO to Pinpoint Test P |
| B1131:55 | Wiper Motor Module: Not Configured | GO to Pinpoint Test O |
| B1131:9A | Wiper Motor Module: Component or System Operating Conditions | DIAGNOSE the symptom present with the wiper/washer system. REFER to the Symptom Chart . |
| B124E:11 | Wiper Stalk Switch Pack: Circuit Short To Ground | GO to Pinpoint Test Q |
| B124E:13 | Wiper Stalk Switch Pack: Circuit Open | GO to Pinpoint Test Q |
| B124E:55 | Wiper Stalk Switch: Not Configured | GO to Pinpoint Test Q |
| B124E:96 | Wiper Stalk Switch Pack: Component Internal Failure | GO to Pinpoint Test Q |
| B124E:9E | Wiper Stalk Switch Pack: Stuck On | GO to Pinpoint Test Q |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.