Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021BRONCO BADLANDS, 2D UTILITY, 2.7L ENG VIN P, PART TIME T/CASE CONTROLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE COOLING - 2.3L ECOBOOST (199KW/270PS))REMOVAL AND INSTALLATIONCOOLANT PUMPREMOVAL
2021 Ford Bronco Badlands, 2D Utility, 2.7L Eng VIN P, Part Time T/Case Control
Coolant Pump: Removal
2021 Ford Bronco Badlands, 2D Utility, 2.7L Eng VIN P, Part Time T/Case ControlSECTION Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Loosen the coolant pump pulley bolts.
- Remove the accessory drive belt. Refer to: Accessory Drive Belt .
- Remove the bolts and the coolant pump pulley.
-
NOTE: Make sure that the mating faces are clean and free of foreign material.
Remove the bolts and the coolant pump.
- Inspect the O-ring seal and replace if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.