Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2019TRANSIT-250 BASE, 2D CAB CHASSIS, 3.2L ENG VIN VREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION, TRANSFER CASE AND POWER TRANSFER UNIT - 6-SPEED AUTOMATIC TRANSMISSION - 6R80 (1 OF 2)DESCRIPTION AND OPERATIONMAIN CONTROL VALVE BODYSOLENOID OPERATION CHARTNOTES
2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN V
Solenoid Operation Chart: Notes
2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN VSECTION Notes
| Base Selector Lever Position | PCM/TCM Commanded Gear | SSA NL (1, 2, 3, 4) | SSB NH (3, 5, R) | SSC NL (2, 6) | SSD NH (L, R, 4, 5, 6) | SSE (On/Off) NC | TCC NL | ||
|---|---|---|---|---|---|---|---|---|---|
| P | P | Off | On | Off | Off | Off | Off | ||
| R | R | Off | Off | Off | Off | Off | Off | ||
| N | N | Off | On | Off | Off | Off | Off | ||
| D | 1 | On | On | Off | Off (2) | Off | Off | ||
| 2 | On | On | On | On | Off | Off | |||
| 3 | On | Off | Off | On | On/Off (1) | On/Off | |||
| 4 | On | On | Off | Off | On | On/Off | |||
| 5 | Off | Off | Off | Off | On | On/Off | |||
| 6 | Off | On | On | Off | On | On/Off | |||
| M (3) | -- | -- | -- | -- | -- | -- | -- | ||
|
|||||||||
|
|||||||||
|
|||||||||
- NC = Normally closed
- NH = Normally high
- NL = Normally low
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.