Connector End View (C3154A) - AUDIO DIGITAL SIGNAL PROCESSING (DSP) MODULE

2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN VSECTION Connector End View (C3154A) - AUDIO DIGITAL SIGNAL PROCESSING (DSP) MODULE
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Color 

GY

Harness 

14A005

Base Part # 

part# N/A

Service Pigtail 

See Below

GFDW83028Courtesy of FORD MOTOR COMPANY

Check for Terminal Part Numbers

Pin  Circuit  Gauge  Circuit Function  Qualifier 
1 VDB29 (GN-BU) 22 CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED 3 (LOWER) HIGH
2 VME09 (WH) 22 CTRL MOD. - AUDIO # SPEAKER LEFT REAR (WOOFER) +
3 SME23 (VT-RD) 22 CTRL MOD. - AUDIO # SUBWOOFER/AMPLIFIER ENABLE
4 VME12 (WH) 22 CTRL MOD. - AUDIO # SPEAKER RIGHT REAR (WOOFER) +
5 VME80 (VT) 26 CTRL MOD. - MULTIMEDIA GATEWAY MODULE # ALERT 1 (+)
6 * * Not Used
7 VME07 (WH) 22 CTRL MOD. - AUDIO # SPEAKER LEFT FRONT DOOR (WOOFER) +
8 * * Not Used
9 VME10 (WH-VT) 22 CTRL MOD. - AUDIO # SPEAKER RIGHT FRONT DOOR (WOOFER) +
10 * * Not Used
11 VDB30 (WH-GN) 22 CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED 3 (LOWER) LOW
12 RME09 (BN) 22 CTRL MOD. - AUDIO # SPEAKER LEFT REAR (WOOFER) -
13 * * Not Used
14 RME12 (BN) 22 CTRL MOD. - AUDIO # SPEAKER RIGHT REAR (WOOFER) -
15 RME80 (BU) 26 CTRL MOD. - MULTIMEDIA GATEWAY MODULE # ALERT 1 (-)
16 * * Not Used
17 RME07 (WH-BN) 22 CTRL MOD. - AUDIO # SPEAKER LEFT FRONT DOOR (WOOFER) -
18 * * Not Used
19 RME10 (WH-OG) 22 CTRL MOD. - AUDIO # SPEAKER RIGHT FRONT DOOR (WOOFER) -
20 * * Not Used
Available Pigtail Kits
Pigtail Kit Part Number

WPT-1199 

GFDW7184Courtesy of FORD MOTOR COMPANY
Service Part Number:

3U2Z-14S411-FCB 

Gauge:

18 

Pin material:

Silver 

Cavities:

20 

Vehicle Uses

Instrument Cluster

Module - Seat Memory

Monitor - Video/DVD

Radio - Amplifier

Switch - Heater A/C Blower (Rear)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.