2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN VFACTORY OEM SERVICE PROCEDURE

DTC U030F - Software Incompatibility With Reductant Control Module

DTC DESCRIPTION U030F - SOFTWARE INCOMPATIBILITY WITH REDUCTANT CONTROL MODULE

Description:  This DTC sets when the PCM receives invalid data from the Reductant Dosage Control Module (RDCM).
Possible Causes: 
  • Communication error
  • RDCM software version
Diagnostic Aids:  Verify the NOx11 module is at the latest calibration level.
The presence of this DTC may indicate the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument panel cluster (IPC) message center.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST AE .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.