Pinpoint Tests RF: Reductant Pressure Sensor: Introduction

2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN VSECTION Introduction
NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

  • reductant pressure sensor
  • harness circuits: RDP, VREF, and SIGRTN
  • reductant dosage control module (5H298)
  • PCM (12A650)
Fig 1: Reductant Pump Assembly Connector
G13533642Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
RDP (Reductant Pressure) 4
VREF (Reference Voltage) 5
SIGRTN (Signal Return) 3
Fig 2: Powertrain Control Module-E (PCM-E) Connector
G13533643Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
RDP (Reductant Pressure) 72
Fig 3: Powertrain Control Module-T (PCM-T) Connector
G13533644Courtesy of FORD MOTOR CO.

Harness Side

Circuit Pin
VREF (Reference Voltage) 1
SIGRTN (Signal Return) 43
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.