Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector End View (C204) - EXTERIOR MIRROR CONTROL SWITCH
| Connector: | Description | Color | Harness | Base Part # | Service Pigtail |
|---|---|---|---|---|---|
| C204 | EXTERIOR MIRROR CONTROL SWITCH | BK | 14K024 | part# N/A | See Below |
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| Pin | Circuit | Gauge | Circuit Function | Qualifier | Terminal Part Number |
|---|---|---|---|---|---|
| 1 | CPM17 (BU-GN) | 20 | SWITCH - POWER MIRROR # LEFT MIRROR UPWARD | ||
| 2 | CPM21 (YE-VT) | 20 | SWITCH - POWER MIRROR # RIGHT MIRROR UPWARD | ||
| 3 | CPM23 (GY) | 20 | SWITCH - POWER MIRROR # COMMON ALL MOTORS | ||
| 4 | GD135 (BK-GY) | 20 | GROUND - COWL SIDE/PILLAR A LEFT # 3RD POINT | ||
| 5 | CPM20 (BN-WH) | 20 | SWITCH - POWER MIRROR # RIGHT MIRROR RIGHTWARD | ||
| 6 | SB135 (BU-RD) | 20 | FUSE - 35 | ||
| 7 | CPM16 (BN-BU) | 20 | SWITCH - POWER MIRROR # LEFT MIRROR RIGHTWARD | ||
| 8 | CPM22 (GY-BN) | 20 | SWITCH - POWER MIRROR # FOLD/DRIVE TOGGLE |
Available Pigtail Kits
Pigtail Kit Part Number WPT-487
Service Part Number:
3U2Z-14S411-RGA
Gauge:
20
Pin material:
Tin
Cavities:
8
Vehicle Uses:
- Switch - Door Lock (RH)
Pigtail Kit Part Number WPT-1272
Service Part Number:
3U2Z-14S411-RGB
Gauge:
14
Pin material:
Tin
Cavities:
8
Vehicle Uses:
- Switch - Power Mirror
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.