Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Heated Seats
Voltage is supplied to the heated seat control switches from the heated seats relay (located in the AJB). The heated seats relay coil is grounded at all times. The heated seats relay coil is energized whenever the ignition is in the ON position. Each heated seat control switch supplies heater current to the seat cushion and backrest heater mats. The heated seat remains on until the heated seat control switch is turned off or the ignition is set to OFF.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.