Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2019EXPLORER XLT, 2.3L ENG VIN H, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0607 - P2091DTC P160A - CONTROL MODULE VEHICLE OPTIONS RECONFIGURATION ERROR
2019 Ford Explorer XLT, 2.3L Eng VIN H, FWD
DTC P160A - Control Module Vehicle Options Reconfiguration Error
2019 Ford Explorer XLT, 2.3L Eng VIN H, FWDSECTION DTC P160A - Control Module Vehicle Options Reconfiguration Error
DTC DESCRIPTION P160A - CONTROL MODULE VEHICLE OPTIONS RECONFIGURATION ERROR
| Description: This DTC sets when the body control module (BCM) detects a mismatch in configuration data and programmable parameters between the PCM and BCM. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Reprogram or update the calibration. If the PCM already has the latest calibration, carry out the relearn vehicle data procedure on the scan tool. Check for other DTCs or drive symptoms for further action. Check for aftermarket performance products. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a replacement PCM. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.