DTC P061C - Internal Control Module Engine RPM Performance

2019 Ford Explorer XLT, 2.3L Eng VIN H, FWDSECTION DTC P061C - Internal Control Module Engine RPM Performance
DTC DESCRIPTION P061C - INTERNAL CONTROL MODULE ENGINE RPM PERFORMANCE

Description:  This DTC sets when an error occurs in the PCM.
Possible Causes: 
  • CKP circuit open
  • CKP circuit short
  • CKP circuit intermittent
  • CMP circuit open
  • CMP circuit short
  • CMP circuit intermittent
  • Damaged crankshaft position (CKP) sensor
  • Damaged camshaft position (CMP) sensor
Diagnostic Aids:  Verify correct operation of the CKP and CMP sensors and related circuits.
The presence of this DTC may indicate that the vehicle is operating in failure mode and may experience a loss of power.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST QE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.