Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2019ESCAPE SEL, 1.5L ENG VIN D, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0607 - P2091DTC P2019 - INTAKE MANIFOLD RUNNER POSITION SENSOR/SWITCH CIRCUIT (BANK 2)
2019 Ford Escape SEL, 1.5L Eng VIN D, FWD
DTC P2019 - Intake Manifold Runner Position Sensor/Switch Circuit (Bank 2)
2019 Ford Escape SEL, 1.5L Eng VIN D, FWDSECTION DTC P2019 - Intake Manifold Runner Position Sensor/Switch Circuit (Bank 2)
DTC DESCRIPTION P2019 - INTAKE MANIFOLD RUNNER POSITION SENSOR/SWITCH CIRCUIT (BANK 2)
| Description: This DTC sets when the IMRC2 circuit voltage is greater than, or less than, a calibrated value. | |||
Possible Causes:
|
|||
| Diagnostic Aids: The IMRC2 sensor value should change when the IMRC is commanded open or closed. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST HU . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.