DTC P2015 - Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance (Bank 1)

2019 Ford Escape SEL, 1.5L Eng VIN D, FWDSECTION DTC P2015 - Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance (Bank 1)
DTC DESCRIPTION P2015 - INTAKE MANIFOLD RUNNER POSITION SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCE (BANK 1)

Description:  This DTC sets when the intake manifold runner control bank 1 (IMRC1) sensor signal is greater than, or less than, an expected calibrated value during self-test.
Possible Causes: 
  • Mechanical concern, damage or restriction of intake manifold runner control (IMRC) hardware
  • Restricted vacuum hoses
Diagnostic Aids:  The IMRC1 sensor value should change when the IMRC is commanded open or closed.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST HU .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.