Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2019ESCAPE SEL, 1.5L ENG VIN D, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0607 - P2091DTC P1013 - WASTEGATE CONTROL PRESSURE SENSOR CIRCUIT HIGH
2019 Ford Escape SEL, 1.5L Eng VIN D, FWD
DTC P1013 - Wastegate Control Pressure Sensor Circuit High
2019 Ford Escape SEL, 1.5L Eng VIN D, FWDSECTION DTC P1013 - Wastegate Control Pressure Sensor Circuit High
DTC DESCRIPTION P1013 - WASTEGATE CONTROL PRESSURE SENSOR CIRCUIT HIGH
| Description: This DTC sets when the wastegate vacuum sensor reading is greater than a calibrated threshold and the fault timer has exceeded the calibrated time threshold indicating an open circuit or a short to voltage. | |||
Possible Causes:
|
|||
| Diagnostic Aids: The typical maximum threshold is 4.93 V and time threshold is 5 seconds. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST HN . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.