DTC P0687 - ECM/PCM Power Relay Control Circuit High

2019 Ford Escape SEL, 1.5L Eng VIN D, FWDSECTION DTC P0687 - ECM/PCM Power Relay Control Circuit High
DTC DESCRIPTION P0687 - ECM/PCM POWER RELAY CONTROL CIRCUIT HIGH

Description:  This DTC sets when the ignition switch position run (ISP-R) circuit indicates the ignition is in the OFF, ACC, or LOCK position, and the amount of time the PCM remains powered through the PCM power relay exceeds a predetermined amount of time.
Possible Causes: 
  • PCMRC circuit short to voltage
  • Damaged PCM power relay
Diagnostic Aids:  Ability to communicate with the PCM when the ignition is in the OFF, ACC, or LOCK position indicates a hard fault.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST B .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.