Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2019ESCAPE SEL, 1.5L ENG VIN D, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) - DTC P0607 - P2091DTC P0607 - CONTROL MODULE PERFORMANCE
2019 Ford Escape SEL, 1.5L Eng VIN D, FWD
DTC P0607 - Control Module Performance
2019 Ford Escape SEL, 1.5L Eng VIN D, FWDSECTION DTC P0607 - Control Module Performance
DTC DESCRIPTION P0607 - CONTROL MODULE PERFORMANCE
| Description: This DTC sets when the PCM internal central processing unit (CPU) has encountered an error. The PCM monitors itself and carries out internal checks of its own CPU. This DTC sets if any of these checks returns an incorrect value. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Reprogram or update the calibration. Check for other DTCs and diagnose those first. Check for aftermarket performance products. Clear the DTCs, repeat the self-test. If the DTC is retrieved again, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a Replacement PCM. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.