Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT-350 BASE, VAN CARGO EXTENDED, 3.2L ENG VIN VREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSOEM CONNECTOR END VIEWS C805A - C2142CONNECTOR VIEWSCONNECTOR END VIEW (C1186) - FUEL INJECTOR 6
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V
Connector End View (C1186) - FUEL INJECTOR 6
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN VSECTION Connector End View (C1186) - FUEL INJECTOR 6
| Connector: | Description | Color | Harness | Base Part # | Service Pigtail |
|---|---|---|---|---|---|
| C1186 | FUEL INJECTOR 6 | GY | 14B485 | part# N/A | See Below |
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| XR8T-14474-CA | Not Available |
| Pin | Circuit | Gauge | Circuit Function | Qualifier | Terminal Part Number | |||
|---|---|---|---|---|---|---|---|---|
| 1 | CE210 (GN-WH) | 16 | CTRL MOD. - POWERTRAIN # FUEL INJECTOR DRIVER 6 (INJ6) | XR8T-14474-CA | ||||
| 2 | RE210 (BN-VT) | 16 | CTRL MOD. - POWERTRAIN # FUEL INJECTOR DRIVER 6 (INJ6RTN) | XR8T-14474-CA | ||||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1282
Service Part Number:
CU2Z-14S411-XA
Gauge:
16
Pin material:
Tin (greased)
Cavities:
2
Vehicle Uses:
- Fuel Injector
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.