Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT-350 BASE, VAN CARGO EXTENDED, 3.2L ENG VIN VREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXLANE KEEPING SYSTEMBCM
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V
Lane Keeping System: BCM
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN VSECTION BCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B120C:11 | Heater for Windshield Mounted Sensor: Circuit Short To Ground | GO to Pinpoint Test C |
| B13AD:11 | Steering Wheel Vibration Actuator: Circuit Short To Ground | GO to Pinpoint Test E |
| B13AD:13 | Steering Wheel Vibration Actuator: Circuit Open | GO to Pinpoint Test E |
| B13AD:1C | Steering Wheel Vibration Actuator: Circuit Voltage Out of Range | GO to Pinpoint Test E |
| B13AD:71 | Steering Wheel Vibration Actuator: Actuator Stuck | GO to Pinpoint Test E |
| B13AD:83 | Steering Wheel Vibration Actuator: Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test E |
| B13AD:87 | Steering Wheel Vibration Actuator: Missing Message | GO to Pinpoint Test E |
| B13AD:96 | Steering Wheel Vibration Actuator: Component Internal Failure | GO to Pinpoint Test E |
| All other BCM Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.