Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT-350 BASE, VAN CARGO EXTENDED, 3.2L ENG VIN VREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWS C100 - C805BCONNECTOR VIEWSCONNECTOR END VIEW (C706A) - SLIDING DOOR CONTACT PLATE LH
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V
Connector End View (C706A) - SLIDING DOOR CONTACT PLATE LH
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN VSECTION Connector End View (C706A) - SLIDING DOOR CONTACT PLATE LH
| Connector: | Description | Color | Harness | Base Part # | Service Pigtail |
|---|---|---|---|---|---|
| C706A | SLIDING DOOR CONTACT PLATE LH | BK | 14401 | part# N/A | See Below |
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| 97BG-14474-AEA | Not Available |
| Pin | Circuit | Gauge | Circuit Function | Qualifier | Terminal Part Number | |||
|---|---|---|---|---|---|---|---|---|
| 1 | CPL53 (WH-OG) | 16 | CTRL MOD. - DOOR LOCK # REAR DRIVER SIDE UNLOCK (INCL.SLIDING DOOR) | 97BG-14474-AEA | ||||
| 2 | CPL02 (VT-GN) | 16 | CTRL MOD. - DOOR LOCK # DRIVER LOCK | 97BG-14474-AEA | ||||
| 3 | * | * | Not Used | N/A | ||||
| 4 | * | * | Not Used | N/A | ||||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1339
Service Part Number:
3U2Z-14S411-SPC
Gauge:
16
Pin material:
Silver
Cavities:
4
Vehicle Uses:
- Actuator - Door Lock - Decklid/Liftgate
- Actuator - Intake Manifold Valve
- Coil - Ignition
- Lamp - Front Cornering/Turn
- Lamp - Park/Turn
- Sensor - Intake Manifold Runner Control
- Sensor - Manifold Absolute Pressure (MAP)
- Sensor - Manifold Pressure/Intake Temperature
- Sensor - Turbine Shaft Speed
- Sensor - Turbo Intake Pressure/Temperature
- Switch - Sliding Door Contact
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.