Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT-350 BASE, VAN CARGO EXTENDED, 3.2L ENG VIN VREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWS C100 - C805BCONNECTOR VIEWSCONNECTOR END VIEW (C328) - INLINE
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V
Connector End View (C328) - INLINE
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN VSECTION Connector End View (C328) - INLINE
| Inline: | Description | Color | Harness | Base Part # | Service Pigtail | |||
|---|---|---|---|---|---|---|---|---|
| C328 | INLINE | BK | 1465915B484 | See Below | ||||
MALE
Harness
14659
FEMALE
Harness
15B484
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| 1L2T-14421-AA | Not Available | |
| 9U5T-14474-MA | DU2Z-14474-BA | 0.64 |
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CLS04 (YE-VT) | 18 | 1L2T-14421-AA | |||
| 2 | * | * | N/A | |||
| Pin | Circuit | Gauge | Qualifier | Terminal Part Number | ||
| 1 | CLS04 (YE-VT) | 18 | 9U5T-14474-MA | |||
| 2 | * | * | N/A | |||
Available Pigtail Kits
Pigtail Kit Part Number WPT-1182
Service Part Number:
BU2Z-14S411-AFA
Gauge:
18
Pin material:
Silver
Cavities:
3
Vehicle Uses:
- Microphone
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.