Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT-350 BASE, VAN CARGO EXTENDED, 3.2L ENG VIN VREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWS C100 - C805BCONNECTOR VIEWSCONNECTOR END VIEW (C250) - IGNITION SWITCH
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V
Connector End View (C250) - IGNITION SWITCH
2018 Ford Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN VSECTION Connector End View (C250) - IGNITION SWITCH
| Connector: | Description | Color | Harness | Base Part # | Service Pigtail |
|---|---|---|---|---|---|
| C250 | IGNITION SWITCH | BK | 14K024 | part# N/A | See Below |
| Terminal Part Number | Service Part Number | Size |
|---|---|---|
| AU5T-14474-DA | Not Available | |
| 92GG-14474-KBB | Not Available | |
| AU5T-14474-CA | Not Available |
| Pin | Circuit | Gauge | Circuit Function | Qualifier | Terminal Part Number | |||
|---|---|---|---|---|---|---|---|---|
| 1 | CDC32 (BN-YE) | 18 | SWITCH - IGNITION # RUN | 92GG-14474-KBB | ||||
| 2 | * | * | Not Used | N/A | ||||
| 3 | CDC41 (WH-BN) | 20 | SWITCH - SOLENOID KEY LOCK (INHIBIT REMOVAL) | AU5T-14474-DA | ||||
| 4 | SBP03 (BU-RD) | 18 | FUSE - 3 OR CIRCUIT BREAKER | 92GG-14474-KBB | ||||
| 5 | CDC30 (BU-GY) | 22 | SWITCH - IGNITION # KEY IN | AU5T-14474-DA | ||||
| 6 | CDC33 (VT-GN) | 18 | SWITCH - IGNITION # RUN; ACCESSORY | AU5T-14474-CA | ||||
| 7 | CDC35 (BU-WH) | 18 | SWITCH - IGNITION # START | 92GG-14474-KBB | ||||
Available Pigtail Kits
Pigtail Kit Part Number WPT-957
Service Part Number:
3U2Z-14S411-FMAB
Gauge:
12 14
Pin material:
Tin & Silver
Cavities:
7
Vehicle Uses:
- Switch - Ignition
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.