SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT CONNECT XL, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE SYSTEM - GENERAL INFORMATIONGENERAL PROCEDURESPOWERTRAIN/DRIVETRAIN MOUNT NEUTRALIZING
2018 Ford Transit Connect XL, Van Cargo

Powertrain/Drivetrain Mount Neutralizing

2018 Ford Transit Connect XL, Van CargoSECTION Powertrain/Drivetrain Mount Neutralizing

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Adjustment 

NOTE: Refer to the appropriate article and procedure for special instructions on loosening and tightening mount fasteners.
  1. Refer to: Jacking and Lifting - Overview .
  2. Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
  3. Lower the vehicle.
  4. NOTE: Do not twist or strain the powertrain/drivetrain mounts or damage to the mounts may occur.

    Start the vehicle and move it in forward 0.6 m (1.97 ft) - 1.2 m (3.94 ft). Then move the vehicle in reverse the same distance.

  5. Raise and support the vehicle.
  6. Tighten the powertrain/drivetrain mount fasteners.
  7. Lower the vehicle.
  8. Test the system for normal operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.