SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT CONNECT XL, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALWIRING DIAGRAMSOEM CONNECTOR END VIEWS - C1671K - C9800CONNECTOR VIEWSCONNECTOR END VIEW (C2800) - ADAPTIVE FRONT LIGHTING MODULE
2018 Ford Transit Connect XL, Van Cargo

Connector End View (C2800) - ADAPTIVE FRONT LIGHTING MODULE

2018 Ford Transit Connect XL, Van CargoSECTION Connector End View (C2800) - ADAPTIVE FRONT LIGHTING MODULE
Connector: Description Color Harness Base Part # Service Pigtail
C2800 ADAPTIVE FRONT LIGHTING MODULE BK 14401 part# N/A See Below
GFDWR19430Courtesy of FORD MOTOR COMPANY
Terminal Part Number  Service Part Number  Size 
Pin  Circuit  Gauge  Circuit Function  Qualifier  Terminal Part Number 
1 CLF34 (YE-OG) 18 CTRL MOD. - MOTOR DYNAMIC BENDING LIGHT RIGHT N/A
2 * * Not Used N/A
3 * * Not Used N/A
4 GD134 (BK-VT) 18 GROUND - PILLAR A LEFT # 2ND STUD N/A
5 * * Not Used N/A
6 * * Not Used N/A
7 VDB05 (WH) 22 CTRL MOD. - GENERIC # UBP BUS (UART BASED PROTOCOL) N/A
8 * * Not Used N/A
9 * * Not Used N/A
10 * * Not Used N/A
11 * * Not Used N/A
12 * * Not Used N/A
13 CLF29 (BN) 18 CTRL MOD. - INDICATOR FOG LAMPS FRONT N/A
14 * * Not Used N/A
15 * * Not Used N/A
16 * * Not Used N/A
17 * * Not Used N/A
18 * * Not Used N/A
19 VDB04 (WH-BU) 22 CONNECTOR - DIAGNOSTIC # CAN BUS HIGH SPEED HIGH N/A
20 * * Not Used N/A
21 * * Not Used N/A
22 * * Not Used N/A
23 * * Not Used N/A
24 CLF12 (BN-YE) 18 CTRL MOD. - CORNERING LAMP RIGHT N/A

Available Pigtail Kits 

Pigtail Kit Part Number WPT-1550

GFDWR801Courtesy of FORD MOTOR COMPANY

Service Part Number:

JU2Z-14S411-AJA 

Gauge:

14 16 20 

Pin material:

Tin & Silver 

Cavities:

24 

Vehicle Uses:

  • Lamp - Front Cornering/ Turn
  • Module - Driver Door
  • Module - Headlamp Control
  • Module - Heated Seat
  • Module - Seat Memory
  • Module - Upfitter Interface
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.