Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT CONNECT XL, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROLREMOVAL AND INSTALLATIONHYDRAULIC CONTROL UNIT (HCU)INSTALLATION
2018 Ford Transit Connect XL, Van Cargo
Hydraulic Control Unit (HCU): Installation
2018 Ford Transit Connect XL, Van CargoSECTION Installation
- Install the HCU and the 3 HCU bracket bolts.
Torque: 89 lb.in (10 Nm)
- Bleed the brake system. Refer to: Brake System Pressure Bleeding .
-
- If a new HCU/ ABS module was installed, using a diagnostic scan tool, complete the PMI process for the ABS module following the on-screen instructions.
- If a new HCU/ ABS module was installed, carry-out the HCU Service Bleed and the IVD Initialization using a diagnostic scan tool and following the scan tool on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.