Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018TRANSIT CONNECT XL, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESMECHANICAL - HYDRAULICFRONT DISC BRAKEREMOVAL AND INSTALLATIONFRONT BRAKE CALIPERINSTALLATION
2018 Ford Transit Connect XL, Van Cargo
Front Brake Caliper: Installation
2018 Ford Transit Connect XL, Van CargoSECTION Installation
- To install, reverse the removal procedure.
- Apply the specified grease to the brake caliper anchor plate as shown.
Material: Multi-Purpose Grease (WSS-M12A4-A2)
-
NOTE: Make sure that the brake hose is not twisted and is correctly located.
Tighten the brake flexible hose fitting.
Torque: 159 lb.in (18 Nm)
- Bleed the brake system. Refer to: Brake System Pressure Bleeding .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.