Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC U0109 - LOST COMMUNICATION WITH FUEL PUMP CONTROL MODULE A
2018 Ford Fusion Platinum Hybrid
DTC U0109 - Lost Communication With Fuel Pump Control Module A
2018 Ford Fusion Platinum HybridSECTION DTC U0109 - Lost Communication With Fuel Pump Control Module A
WARNING: This page is about a different variant/trim than selected.
U0109 - LOST COMMUNICATION WITH FUEL PUMP CONTROL MODULE A
| Description: | The PCM monitors the fuel pump monitor (FPM) circuit for the presence of a duty cycled signal. If the FPM circuit is fixed at a low or high voltage, the PCM begins to increment a counter. This DTC sets when the PCM is still not detecting a duty cycled signal on the FPM circuit after a calibrated amount of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check if the inertia fuel shutoff (IFS) switch is tripped. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST KC . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.