SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P2196 - O2 SENSOR SIGNAL BIASED/STUCK RICH (BANK 1 SENSOR 1)
2018 Ford Fusion Platinum Hybrid

DTC P2196 - O2 Sensor Signal Biased/Stuck Rich (Bank 1 Sensor 1)

2018 Ford Fusion Platinum HybridSECTION DTC P2196 - O2 Sensor Signal Biased/Stuck Rich (Bank 1 Sensor 1)
WARNING: This page is about a different variant/trim than selected.
P2196 - O2 SENSOR SIGNAL BIASED/STUCK RICH (BANK 1 SENSOR 1)

Description:  A heated oxygen sensor bank 1, sensor 1 (HO2S11) indicating rich at the end of a test is trying to correct for an over rich condition. This DTC sets when the fuel control system no longer detects switching for a calibrated amount of time.
Possible Causes: 
  • Water in the harness connector
  • UO2SPC11 circuit open (if equipped)
  • HO2S11 circuit open (if equipped)
  • Corrosion
  • Incorrect connections
  • Excessive fuel pressure
  • Leaking or contaminated fuel injectors
  • EVAP purge valve stuck open
  • Biased MAP sensor signal (if equipped)
  • Incorrect learned ethanol content
  • Contaminated MAF sensor (if equipped)
  • Positive crankcase ventilation (PCV) system
  • Contaminated oil
  • Oil overfill
  • Camshaft timing
  • Damaged universal HO2S11 (if equipped)
  • Damaged HO2S11 (if equipped)
  • Damaged PCM
Diagnostic Aids: 
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST H .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.