Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P060B - INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
2018 Ford Fusion Platinum Hybrid
DTC P060B - Internal Control Module A/D Processing Performance
2018 Ford Fusion Platinum HybridSECTION DTC P060B - Internal Control Module A/D Processing Performance
WARNING: This page is about a different variant/trim than selected.
P060B - INTERNAL CONTROL MODULE A/D PROCESSING PERFORMANCE
| Description: | This DTC sets when an error occurs in the PCM. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Inspect the wiring harness for damage. Verify correct operation of the sensors using VREF and related circuits. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST QE . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.