Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 26 (ELECTRONIC ENGINE CONTROLS SYSTEM - 2.7L ECOBOOST (238KW/324PS))DIAGNOSIS AND TESTINGELECTRONIC ENGINE CONTROLSPINPOINT TESTSPINPOINT TEST L : OIL PRESSURE CONTROL SOLENOID FAULTSNOTES
2018 Ford Fusion Platinum Hybrid
Pinpoint Test L : Oil Pressure Control Solenoid Faults: Notes
2018 Ford Fusion Platinum HybridSECTION Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Electronic Engine Controls for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Engine - Overview .
DTC Fault Trigger Condition-PCM
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06DA | Engine Oil Pressure Control Circuit/Open | Sets when the PCM detects an open on the engine oil pressure control solenoid valve circuit. |
| P06DB | Engine Oil Pressure Control Circuit Low | Sets when the PCM detects a short to ground on the engine oil pressure control solenoid valve circuit. |
| P06DC | Engine Oil Pressure Control Circuit High | Sets when the PCM detects a short to voltage on the engine oil pressure control solenoid valve circuit. |
| P06DD | Engine Oil Pressure Control Circuit Performance/Stuck Off | Sets when the PCM detects the engine oil pressure control solenoid valve is stuck. |
Possible Sources
- Engine oil pressure control solenoid valve
- PCM
- Wiring, terminals or connectors
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.