Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2018FUSION PLATINUM HYBRIDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 139 (ENGINE CONTROLS - FUEL CHARGING AND CONTROLS - 2.7L ECOBOOST (238KW/324PS))REMOVAL AND INSTALLATIONFUEL PUMP DRIVER MODULE (FPDM)INSTALLATION
2018 Ford Fusion Platinum Hybrid
Fuel Pump Driver Module (FPDM): Installation
2018 Ford Fusion Platinum HybridSECTION Installation
WARNING: This page is about a different variant/trim than selected.
-
- Install the fuel pump driver module, then install and tighten the fuel pump driver module retaining nuts.
Torque: 13 lb.in (1.5 Nm)
- Connect the fuel pump driver module electrical connector.
- Install the fuel pump driver module, then install and tighten the fuel pump driver module retaining nuts.
- Install the left C-pillar lower trim panel. Refer to: C-Pillar Lower Trim Panel .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.